Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA1999626 ES, 2.5 D, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 438 (FUEL SYSTEM)QUICK RELEASE CONNECTOR REMOVAL/INSTALLATIONROLLOVER VALVEREMOVAL
1999 Mazda 626 ES, 2.5 D, Standard
Rollover Valve: Removal
1999 Mazda 626 ES, 2.5 D, StandardSECTION Removal
WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Squeeze the tabs on the quick release connector and disconnect the fuel hose from the fuel pipe.
- Cover the disconnected quick release connector and fuel pipe with vinyl sheeting or a similar material to prevent it from being scratched or contaminated with foreign material.NOTE:
- Take care not to damage or soil the fuel hose.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.