Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMAZDA1999626 ES, 2.5 D, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 335 (SYMPTOM TROUBLESHOOTING (ENGINE CONTROL SYSTEM AJ))NO. 3 WILL NOT CRANKNOTES

1999 Mazda 626 ES, 2.5 D, Standard

No. 3 Will Not Crank: Notes

1999 Mazda 626 ES, 2.5 D, StandardSECTION Notes

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

DESCRIPTION & POSSIBLE CAUSE

3	Will not crank
DESCRIPTION	Starter does not work.
POSSIBLE CAUSE	Open starter circuit between ignition switch and starter TR switch malfunction (ATX) TR switch misadjustment (ATX) Low or dead battery Charging system malfunction Starter interlock switch malfunction (MTX) Starter malfunction Seized/hydro locked engine, flywheel or drive plate Immobilizer system (PATS) and/or circuit malfunction

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.