Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA1999626 ES, 2.5 D, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 252 (ENTERTAINMENT SYSTEM)CENTER PANEL MODULE REMOVAL/INSTALLATIONCENTER PANEL MODULE REMOVAL NOTE
1999 Mazda 626 ES, 2.5 D, Standard
Center Panel Module Removal Note
1999 Mazda 626 ES, 2.5 D, StandardSECTION Center Panel Module Removal Note
WARNING: This page is about a different car, the 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Pull the center panel module outward, detach clip A from the dashboard, and then remove the center panel module.
Connector Removal Note
- Put your hand through the opening where the ventilator grille was removed and disconnect the connectors.CAUTION:
- When putting your hand through the opening, be careful not to contact the panel edge or sharp parts to avoid injury.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.