Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA1999626 ES, 2.5 D, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 142 (POWER STEERING)POWER STEERING HOSE REMOVAL/INSTALLATIONINSTALLATION
1999 Mazda 626 ES, 2.5 D, Standard
Power Steering Hose Removal/Installation: Installation
1999 Mazda 626 ES, 2.5 D, StandardSECTION Installation
WARNING: This page is about a different car, the 2002 Mazda B4000, 2002 Mazda B3000, and 2002 Mazda B2300. However, it is still accessible from the selected car via links, so may be relevant.
- When connecting a fitting with a seal ring, the ring must be replaced.
- Use Seal Replacer Set 211-D027 (D90P-3517-A) or equivalent to install the return line connector seal and the pressure line connector seal.
Tightening Torque
48 N.m {4.9 kgf.m, 35 ft.lbf}
- Fill and leak check the system.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.