SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA1999626 ES, 2.5 D, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 119 (FRONT SUSPENSION SYSTEM)FRONT LOWER ARM (REAR)REMOVAL/INSTALLATIONFRONT LOWER ARM (REAR) REMOVAL NOTE
1999 Mazda 626 ES, 2.5 D, Standard

Front Lower Arm (Rear) Removal Note

1999 Mazda 626 ES, 2.5 D, StandardSECTION Front Lower Arm (Rear) Removal Note
WARNING: This page is about a different car, the 2004 Mazda 6 and 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Loosen the front crossmember installation bolts (front side).
  2. Lower the front crossmember, and remove the front lower arm bolt (inner side).
    Fig 1: Removing Front Lower Arm (Rear)
    G00375853Courtesy of MAZDA MOTORS CORP.
  3. Remove the front lower arm (rear).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.