Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Verification Drive Cycle
Cold soak vehicle for 8 hours before performing EVAP test. Connect scan tool. Turn all accessories off. Start engine. Accelerate to 40 MPH within 20 seconds. Drive vehicle at 35-45 MPH for 5.5 minutes. Accelerate to 50-60 MPH within 10 seconds and remain at that speed for at least 2 minutes. Stop vehicle and allow to idle for 20 seconds. Using scan tool, check drive mode completion status. If test is not complete, repeat test from engine start. If test is complete, check test results. If results are okay, ensure no DTCs are present. If results are not okay, repairs are not complete.
To bypass 8 hour timer, cool fuel tank as much as possible. Connect scan tool. Access CLEAR DIAGNOSTIC CODES. Press TRIGGER to reset timer. Leave ignition on. Perform drive mode test.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.