Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Using New Generation Star (NGS) Tool
Turn ignition switch to OFF position. Connect New Generation Star (NGS) scan tool (49-T088-0A0) to Data Link Connector (DLC). Set NGS Self-Test Adapter (49-T088-003) to ABS. Select VEHICLE & ENGINE SELECTION, then select NEW VEHICLE YEAR & MODEL and select model year (1999 or 2000). Select DIAGNOSTIC DATA LINK. Select ABS-ANTI LOCK BRAKE MODULE. Select DIAGNOSTIC TEST MODES then select READ/CLEAR DIAGNOSTIC TEST RESULTS. Press CLEAR, then press trigger.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.