Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA1999626 ES, 2.5 D, STANDARDREPAIR AND DIAGNOSISBRAKESANTI-LOCK BRAKES/TRACTION CONTROL (2)ADDITIONAL SYSTEM FUNCTIONSACTIVE COMMAND MODES PROCEDURE
1999 Mazda 626 ES, 2.5 D, Standard
Active Command Modes Procedure
1999 Mazda 626 ES, 2.5 D, StandardSECTION Active Command Modes Procedure
Active command mode allows devices such as relays or solenoids to be actuated through NGS scan tool. Turn ignition switch to OFF position. Ensure test equipment is properly attached. Program scan tool using the following steps:
- Select VEHICLE & ENGINE SELECTION.
- Select NEW VEHICLE YEAR & MODEL (1999 or 2000).
- Select DIAGNOSTIC DATA LINK.
- Select ABS-ANTI LOCK BRAKE MODULE.
- Select ACTIVE COMMAND MODES.
- Select ABS OUTPUT CONTROL, INDICATOR LAMP CONTROL II or DESIRED ENGINE TORQUE.
- Turn ignition switch to ON position or start engine and allow to idle.
- Select appropriate active command mode. For active command modes, see 1999 ACTIVE COMMAND MODE DEFINITIONS or 2000 ACTIVE COMMAND MODE DEFINITIONS tables.
1999 ACTIVE COMMAND MODE DEFINITIONS
| Command | Definition | Mode | ||
|---|---|---|---|---|
| ABS LMP | ABS Warning Light | ON/OFF | ||
| ENG TQR (1) | Engine Torque | Engine Torque Amount | ||
| LF AV | Left Front Dump Valve | ON/OFF | ||
| LF EV | Left Front Isolation Valve | ON/OFF | ||
| LR AV | Left Rear Dump Valve | ON/OFF | ||
| LR EV | Left Rear Isolation Valve | ON/OFF | ||
| PMP RLY | Pump Motor Relay | ON/OFF | ||
| RF AV | Right Front Dump Valve | ON/OFF | ||
| RF EV | Right Front Isolation Valve | ON/OFF | ||
| RR AV | Right Rear Dump Valve | ON/OFF | ||
| RR EV | Right Rear Isolation Valve | ON/OFF | ||
| TCS LMP (1) | TCS Indicator Light | ON/OFF | ||
| TCS OFF (1) | TCS OFF Light | ON/OFF | ||
|
||||
2000 ACTIVE COMMAND MODE DEFINITIONS
| Command | Definition | Mode | ||
|---|---|---|---|---|
| ABS LMP | ABS Warning Light | ON/OFF | ||
| CHK TRAC (1) | Check Traction Control Indicator | ON/OFF | ||
| ENG TQR (1) | Engine Torque Reduction Signal Output | Engine Torque Amount | ||
| LF INLET | Left Front Isolation Valve | ON/OFF | ||
| LF OUTLET | Left Front Dump Valve | ON/OFF | ||
| LR INLET | Left Rear Isolation Valve | ON/OFF | ||
| LR OUTLET | Left Rear Dump Valve | ON/OFF | ||
| PMP MOTR | Hydraulic Pump Motor | ON/OFF | ||
| RF INLET | Right Front Isolation Valve | ON/OFF | ||
| RF OUTLET | Right Front Dump Valve | ON/OFF | ||
| RR INLET | Right Rear Isolation Valve | ON/OFF | ||
| RR OUTLET | Right Rear Dump Valve | ON/OFF | ||
| TCS LMP (1) | TCS Indicator Light | ON/OFF | ||
| TRAC OFF (1) | TCS OFF Light | ON/OFF | ||
| VPWR RLY | Valve Power Relay | ON/OFF | ||
|
||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.