Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA1999626 ES, 2.5 D, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSADJUSTMENTSTRANSMISSION RANGE SWITCHLA4A-EL TRANSMISSION
1999 Mazda 626 ES, 2.5 D, Standard
LA4A-EL Transmission
1999 Mazda 626 ES, 2.5 D, StandardSECTION LA4A-EL Transmission
Place transmission in Neutral. Loosen Transmission Range (TR) switch retaining screws. Using Alignment Tool (49-UN01-086), align TR switch. Tighten TR switch retaining screws to 96-117 INCH lbs. (11-13 N.m). Remove alignment tool.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.