Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Transmission Range Sensor (A/T)
Using DVOM, backprobe PCM connector pin No. 64 (Light Blue/Yellow wire). Measure voltage while moving selector through each gear range. If voltage is not as specified, check wiring harness. If wiring harness is okay, replace TRS. See TRANSMISSION RANGE SENSOR VOLTAGE table.
| Gear Position | Volts |
|---|---|
| Park | 4.32-4.68 |
| Reverse | 3.52-3.89 |
| Neutral | 2.80-3.10 |
| Drive | 2.09-2.31 |
| 2 | 1.39-1.53 |
| 1 | 0.68-0.76 |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.