Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA1995B4000 4WD V6-4.0L OHVREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECYLINDER BLOCK ASSEMBLYSYSTEM SPECIFICATIONSGENERAL SPECIFICATIONS
1995 Mazda B4000 4WD V6-4.0L OHV
General Specifications
1995 Mazda B4000 4WD V6-4.0L OHVSECTION General Specifications
Head Gasket Surface Flatness:
0.003 In Any 6 Inches - 0.006 Overall
Finish (RMS) 60 - 150
Crankshaft to Rear Face of Block Runout:
T.I.R. Max. 0.005
Taper Bore Diameter 0.8750 - 0.8760
Main Bearing Bore Diameter 2.3866 - 2.3874
Cylinder Bore:
Diameter 3.9527 - 3.9543
Surface Finish (RMS) 18.38
Out-of Round 0.0015
Out-Of-Round Service Limit 0.005
Taper Service Limit 0.010
0.003 In Any 6 Inches - 0.006 Overall
Finish (RMS) 60 - 150
Crankshaft to Rear Face of Block Runout:
T.I.R. Max. 0.005
Taper Bore Diameter 0.8750 - 0.8760
Main Bearing Bore Diameter 2.3866 - 2.3874
Cylinder Bore:
Diameter 3.9527 - 3.9543
Surface Finish (RMS) 18.38
Out-of Round 0.0015
Out-Of-Round Service Limit 0.005
Taper Service Limit 0.010
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.