Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA1995B4000 4WD V6-4.0L OHVREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTHROTTLE POSITION SENSORSERVICE AND REPAIR
1995 Mazda B4000 4WD V6-4.0L OHV
Throttle Position Sensor: Service and Repair
1995 Mazda B4000 4WD V6-4.0L OHVSECTION Service and Repair
REMOVAL / INSTALLATION
1. Disconnect the throttle position sensor connector.
2. Remove the throttle position sensor screws.
3. Remove the throttle position sensor.
Caution:
^ Slide rotary tangs into position over throttle shaft blade, then rotate throttle position sensor clockwise only to install position.
^ Failure to install throttle position sensor in this manner may result in excessive idle speeds.
4. Install in the reverse order of removal.
Tightening torque: 3 N-m (27 in-lb)
1. Disconnect the throttle position sensor connector.
2. Remove the throttle position sensor screws.
3. Remove the throttle position sensor.
Caution:
^ Slide rotary tangs into position over throttle shaft blade, then rotate throttle position sensor clockwise only to install position.
^ Failure to install throttle position sensor in this manner may result in excessive idle speeds.
4. Install in the reverse order of removal.
Tightening torque: 3 N-m (27 in-lb)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.