Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA1995B3000 SE, 2D PICKUP EXTRA CAB, AUTOMATICREPAIR AND DIAGNOSISENGINE MECHANICALACCESSORY DRIVE BELTSCOOLING SYSTEM SPECIFICATIONS & DRIVE BELT ROUTINGCOOLING SYSTEM SPECIFICATIONS
1995 Mazda B3000 SE, 2D Pickup Extra Cab, Automatic
Cooling System Specifications
1995 Mazda B3000 SE, 2D Pickup Extra Cab, AutomaticSECTION Cooling System Specifications
COOLING SYSTEM SPECIFICATIONS
| Model | Specification | ||||
|---|---|---|---|---|---|
| B2300 | |||||
| Coolant Replacement Interval | (1) | ||||
| Coolant Capacity | |||||
| With A/C | 7.2 Qts. (6.8L) | ||||
| Without A/C | 6.5 Qts. (6.2L) | ||||
| Pressure Cap | 12 psi (0.9 kg/cm2 ) | ||||
| Thermostat Open Temperature | |||||
| Starts | 192°F (89°C) | ||||
| Fully Open | 212°F (100°C) | ||||
| Thermostat Open Lift | 0.126" (3.2 mm) | ||||
| B3000 | |||||
| Coolant Replacement Interval | (1) | ||||
| Coolant Capacity | |||||
| With A/C | 10.2 Qts. (9.6L) | ||||
| Without A/C | 9.5 Qts. (9.0L) | ||||
| Pressure Cap | 12 psi (0.9 kg/cm2 ) | ||||
| Thermostat Opens | |||||
| Starts | 192°F (89°C) | ||||
| Fully Open | 212°F (100°C) | ||||
| Thermostat Open Lift | 0.126" (3.2 mm) | ||||
| B4000 | |||||
| Coolant Replacement Interval | (1) | ||||
| Coolant Capacity | |||||
| With A/C | 8.6 Qts. (8.1L) | ||||
| Without A/C | 7.8 Qts. (7.4L) | ||||
| Pressure Cap | 12 psi (0.9 kg/cm2 ) | ||||
| Thermostat Opens | |||||
| Starts | 192°F (89°C) | ||||
| Fully Open | 212°F (100°C) | ||||
| Thermostat Open Lift | 0.126" (3.2 mm) | ||||
|
|||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.