Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA1995B2300 BASE, 2D PICKUP, RWD, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALMECHANICAL2.3L 4-CYL VIN [A]ENGINE SPECIFICATIONSCYLINDER HEAD SPECIFICATIONS
1995 Mazda B2300 Base, 2D Pickup, RWD, Automatic
Cylinder Head Specifications
1995 Mazda B2300 Base, 2D Pickup, RWD, AutomaticSECTION Cylinder Head Specifications
CYLINDER HEAD
| Application | Specification | |||||
|---|---|---|---|---|---|---|
| Maximum Warpage (1) | .003" (.08 mm) | |||||
| Valve Seats | ||||||
| Intake Valve | ||||||
| Seat Angle | 45° | |||||
| Seat Width | .068-.088" (1.73-2.24 mm) | |||||
| Maximum Seat Runout | .0020" (.051 mm) | |||||
| Exhaust Valve | ||||||
| Seat Angle | 45° | |||||
| Seat Width | .070-.090" (1.78-2.29 mm) | |||||
| Maximum Seat Runout | .0020" (.051 mm) | |||||
| Valve Guides | ||||||
| Intake Valve | ||||||
| Bore Diameter | .3433-.3443" (8.720-8.745 mm) | |||||
| Valve Stem-To-Guide Oil Clearance | ||||||
| Standard | .0010-.0027" (.025-.069 mm) | |||||
| Service Limit | .0055" (.140 mm) | |||||
| Exhaust Valve | ||||||
| Bore Diameter | .3433-.3443" (8.720-8.745 mm) | |||||
| Valve Stem-To-Guide Oil Clearance | ||||||
| Standard | .0015-.0032" (.038-.081 mm) | |||||
| Service Limit | .0055" (.140 mm) | |||||
|
||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.