SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA1995B2300 BASE, 2D PICKUP, RWD, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEM - REAR WHEELCOMPONENT TESTINGRABS CONTROL MODULE TEST
1995 Mazda B2300 Base, 2D Pickup, RWD, Automatic

RABS Control Module Test

1995 Mazda B2300 Base, 2D Pickup, RWD, AutomaticSECTION RABS Control Module Test
NOTE: Use a fine wire probe when testing RABS control module connector terminals to prevent damage to connector.

Disconnect negative battery cable. Disconnect RABS control module harness connector. See COMPONENT LOCATIONS  . Using DVOM, measure voltage between applicable terminal of RABS control module harness connector and ground. See Fig 1 . If voltage is not as specified, replace RABS control module.

Fig 1: Testing RABS Control Module
G96H20062Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.