Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA1995626 LX, 2.5 D, STANDARDREPAIR AND DIAGNOSISTRANSMISSIONCLUTCHESOVERHAULCLUTCH MASTER CYLINDERDISASSEMBLY
1995 Mazda 626 LX, 2.5 D, Standard
Clutch Master Cylinder: Disassembly
1995 Mazda 626 LX, 2.5 D, StandardSECTION Disassembly
- Remove clutch master cylinder. See CLUTCH MASTER CYLINDER under REMOVAL & INSTALLATION. Remove clutch master cylinder-to-brake master cylinder flexible hose. Press piston inward. Remove snap ring carefully, without scratching cylinder bore. See Figure .
- Remove piston and secondary cup by placing shop rag over piston and lightly applying air pressure to fluid line fitting. Remove primary cup and return spring. Remove elbow joint and bushing. See Figure .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.