Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Mazda MX-6 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Trouble Code Identification Table
TROUBLE CODE IDENTIFICATION
| DTC | Description |
|---|---|
| CODE 2 | Crankshaft Position Sensor - NE Signal |
| CODE 3 | Crankshaft Position Sensor - G Signal |
| CODE 6 | Vehicle Speed Sensor |
| CODE 8 | Airflow Sensor |
| CODE 9 | Engine Coolant Temperature Sensor - CIS |
| CODE 11 | Intake Air Temperature Sensor |
| CODE 12 | Throttle Position Sensor |
| CODE 14 | Barometric Absolute Pressure Sensor/MTX |
| CODE 14 | Barometric Absolute Pressure Sensor/ATX |
| CODE 15 | Heated Oxygen Sensor |
| CODE 16 | EGR Function Sensor - California |
| CODE 17 | Closed Loop System |
| CODE 25 | Solenoid Valve - Pressure Regulator |
| CODE 26 | Solenoid Valve - Purge Control |
| CODE 28 | Solenoid Valve - EGR Control |
| CODE 34 | Idle Air Control Valve |
| CODE 55 | Vehicle Speed Pulse Generator - ATX |
| CODE 56 | ATF Thermosensor - ATX |
| CODE 60 | Solenoid Valve 1-2 Shift - ATX |
| CODE 61 | Solenoid Valve 2-3 Shift - ATX |
| CODE 62 | Solenoid Valve 3-4 Shift - ATX |
| CODE 63 | Solenoid Valve Lock-Up Control - ATX |
| CODE 64 | Solenoid Valve 3-2 Timing - ATX |
| CODE 65 | Solenoid Valve Lock-Up - ATX |
| CODE 66 | Solenoid Valve Line Pressure - ATX |
| CODE 67 | Coolant Fan Relay No. 1 |
| CODE 68 | Coolant Fan Relay No. 2 & 3 - ATX |
| CODE 69 | Engine Coolant Temperature Sensor |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
