Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Mazda MX-6 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Engine Controls - Tests W/Codes - 2.0L
- Introduction
- Self-Diagnostic System
- Trouble Code Identification
- Notes
- Trouble Code Identification Table
- Code 2: (Crankshaft Position Sensor - Ne Signal)
- Code 3: (Crankshaft Position Sensor - G Signal)
- Code 6: (Vehicle Speed Sensor)
- Code 8: (Airflow Sensor)
- Code 9: (Engine Coolant Temperature Sensor - Cis)
- Code 11: (Intake Air Temperature Sensor)
- Code 12: (Throttle Position Sensor)
- Code 14: (Barometric Absolute Pressure Sensor/MTX)
- Code 14: (Barometric Absolute Pressure Sensor/ATX)
- Code 15: (Heated Oxygen Sensor)
- Code 16: (EGR Function Sensor - CALIFORNIA)
- Code 17: (Closed Loop System)
- Code 25: (Solenoid Valve - Pressure Regulator Control)
- Code 26: (Solenoid Valve - Purge Control)
- Code 28: (Solenoid Valve - EGR Control)
- Code 34: (Idle Air Control Valve)
- Code 55: (Vehicle Speed Pulse Generator - ATX)
- Code 56: (ATF THERMOSENSOR - ATX)
- Code 60: (Solenoid Valve 1-2 Shift - ATX)
- Code 61: (Solenoid Valve 2-3 Shift - ATX)
- Code 62: (Solenoid Valve 3-4 Shift - ATX)
- Code 63: (Solenoid Valve Lock-Up Control - ATX)
- Code 64: (Solenoid Valve 3-2 Timing - ATX)
- Code 65: (Solenoid Valve Lock-Up - ATX)
- Code 66: (Solenoid Valve Line Pressure - ATX)
- Code 67: (Coolant Fan Relay No. 1)
- Code 68: (Coolant Fan Relay No. 2 & 3 - ATX)
- Code 69: (Engine Coolant Temperature Sensor)
- Summary
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
