Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA1993MX-3 V6-1844CC 1.8L DOHCREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTFUEL DELIVERY AND AIR INDUCTIONFUEL PUMPSERVICE AND REPAIR
1993 Mazda MX-3 V6-1844cc 1.8L DOHC
Fuel Pump: Service and Repair
1993 Mazda MX-3 V6-1844cc 1.8L DOHCSECTION Service and Repair
WARNING: Explosion and fire hazard. Observe the following precautions when working on the fuel tank.
^ Be sure area is well ventilated.
^ Always relieve fuel system pressure before disconnecting fuel lines.
^ Do not smoke or light cigarettes where fuel vapor odor is present.
^ Disconnect battery. Do not create sparks or flames where fuel vapor odor is present.
COMPONENTS
2. Fuel pump cover
3. Gauge unit connection
4. Hoses
5. Pump gauge
6. Pump connector
7. Bracket
8. Rubber mount
9. Fuel pump
10. Fuel filter (low pressure side)
REMOVAL AND REPLACEMENT
1. Relieve fuel system pressure.
2. Remove rear seat cushion.
3. Disconnect fuel tank gauge unit electrical connector and remove access cover.
4. Disconnect fuel hoses.
5. Remove fuel pump/gauge unit from tank.
6. Install in reverse order.
NOTE: Do not apply excessive force when hose onto fuel pump nipple. After installing pump to bracket, pull pump down tight against bracket.
^ Be sure area is well ventilated.
^ Always relieve fuel system pressure before disconnecting fuel lines.
^ Do not smoke or light cigarettes where fuel vapor odor is present.
^ Disconnect battery. Do not create sparks or flames where fuel vapor odor is present.
Fuel Pump Assembly And Installation:
COMPONENTS
2. Fuel pump cover
3. Gauge unit connection
4. Hoses
5. Pump gauge
6. Pump connector
7. Bracket
8. Rubber mount
9. Fuel pump
10. Fuel filter (low pressure side)
REMOVAL AND REPLACEMENT
1. Relieve fuel system pressure.
2. Remove rear seat cushion.
3. Disconnect fuel tank gauge unit electrical connector and remove access cover.
4. Disconnect fuel hoses.
5. Remove fuel pump/gauge unit from tank.
6. Install in reverse order.
NOTE: Do not apply excessive force when hose onto fuel pump nipple. After installing pump to bracket, pull pump down tight against bracket.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.