Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA1993B2200 LE-5, 2D PICKUP, AUTOMATICREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROLS - ADJUSTMENTSIDLE SPEED & MIXTUREIDLE MIXTUREB2200 (CARBURETED)
1993 Mazda B2200 LE-5, 2D Pickup, Automatic
B2200 (Carbureted)
1993 Mazda B2200 LE-5, 2D Pickup, AutomaticSECTION B2200 (Carbureted)
- Check for presence of mixture screw roll pin. See Figure . If roll pin has already been removed, go to next step. If roll pin is present, remove air cleaner and carburetor. Drive out mixture screw roll pin. Install carburetor.
- Install air cleaner. Ensure idle compensator valve is closed. Warm engine to normal operating temperature. Connect dwell meter (on4-cylinder setting) between ground and mixture check connector (Brown/Yellow wire). See Figure .
- Adjust idle speed to 825 RPM. Turn mixture adjusting screw until dwell reading is 27-45 degrees. Reset idle speed (if necessary). Replace mixture roll pin after adjustment. If mixture cannot be adjusted to specification, see TESTS W/O CODES article.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.