Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA1993B2200 LE-5, 2D PICKUP, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - SYSTEM/COMPONENT TESTS - EFIIDLE CONTROL SYSTEMIDLE SPEED CONTROL (ISC) SYSTEM (RX7)ISC VALVE
1993 Mazda B2200 LE-5, 2D Pickup, Automatic
ISC Valve
1993 Mazda B2200 LE-5, 2D Pickup, AutomaticSECTION ISC Valve
- Make sure fast idle cam has released throttle lever. See Figure . Disconnect ISC valve electrical connector. Connect ohmmeter to ISC valve 2-wire connector. See Figure . Measure resistance. Resistance should be 10.7-12.3 ohms at 68°F (20°C). If resistance is not within specification, replace ISC valve.
- With engine idling at operating temperature, disconnect ISC valve electrical connector. Engine speed should increase to 1000-1500 RPM. If engine speed does not increase, replace ISC valve.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.