Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA1991RX-7 BASE, 2D CONVERTIBLE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEPOWER WINDOWSCOMPONENT LOCATIONS
1991 Mazda RX-7 Base, 2D Convertible, Standard
Component Locations
1991 Mazda RX-7 Base, 2D Convertible, StandardSECTION Component Locations
COMPONENT LOCATIONS
| Component | Location |
|---|---|
| Fuse Box | In Left Kick Panel. See Fig 1. |
| Power Window Master Control Switch | Driver's Door Armrest |
| Power Window Motor | Inside Respective Door |
| Passenger Power Window Switch | Passenger Door Armrest |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.