Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA1991PROTEGE 4WD, AUTOMATICREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSDIAGNOSIS - F4A-EL, FA4A-L & G4AX-ELCOMPONENT TESTSSPEED SENSORNOTES
1991 Mazda Protege 4WD, Automatic
Speed Sensor: Notes
1991 Mazda Protege 4WD, AutomaticSECTION Notes
- Connect voltmeter between PCMT terminal 1M and ground.
- Turn ignition on, remove speedometer cable from transmission and turn speedometer cable one turn. There should be about 7 volts, indicated 4 times in one revolution. See appropriate control unit connector in CONTROL UNIT CONNECTORS & TERMINAL VOLTAGE CHARTS.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.