Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA1991NAVAJO LX, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTWINDOW MOTORS & REGULATORSPOWER WINDOWSADJUSTMENTSWINDOW MECHANISM
1991 Mazda Navajo LX, Automatic
Window Mechanism
1991 Mazda Navajo LX, AutomaticSECTION Window Mechanism
- Remove door trim panel and water shield. See DOOR TRIM PANEL & WATER SHIELD under REMOVAL & INSTALLATION. Lower glass about 3" (75 mm) from full UP position.
- Loosen nut and washer assemblies retaining equalizer bracket to door inner panel. See Figure . Open door and place hands on each side of glass. Carefully pull glass fully into door glass run assembly at "B" pillar.
- Tighten nut and washer. Apply downward pressure on equalizer bracket and tighten nut and washer to 7-10 ft. lbs. (9-14 N.m). Cycle door glass to ensure proper functioning and door fit. Install water shield and trim panel. See DOOR TRIM PANEL & WATER SHIELD under REMOVAL & INSTALLATION.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.