Injector Delivery Volume

1991 Mazda MX-6 LX, StandardSECTION Injector Delivery Volume
  1. With delivery pipe and injectors removed, secure injectors tightly onto delivery pipe with wire. Install hose on injector. Install Injector Checker (49 B092 953) on injector. See Fig 1 .
  2. Install jumper between 2 terminals of fuel pump test circuit connector. See BASIC TESTING article for test connector location. Turn ignition on. Connect injector checker to battery voltage. Note injector volume after 15 seconds.
  3. Replace injectors which do not meet volume specifications. See INJECTOR VOLUME SPECIFICATIONS table. Check primary and secondary injectors in the same manner.
CAUTION: Use care when connecting injector checker to prevent sparks around fuel area.
INJECTOR VOLUME SPECIFICATIONS

Application Oz. (cc)
Non-Turbo 1.35-1.80 (45-60)
Turbo 2.25-2.70 (75-90)
Fig 1: Testing Injector Delivery Volume
G117783Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.