Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA1991MX-6 GT, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)SUSPENSIONWHEEL ALIGNMENTWHEEL ALIGNMENT SPECIFICATIONS & PROCEDURESWHEEL ALIGNMENT PROCEDURESTOE-IN ADJUSTMENT (REAR)
1991 Mazda MX-6 GT, Standard
Toe-In Adjustment (Rear)
1991 Mazda MX-6 GT, StandardSECTION Toe-In Adjustment (Rear)
NOTE:
Both left and right tie-rods have right-hand threads. To increase toe-in, turn right tie-rod toward front of vehicle, and turn left tie-rod the same amount toward rear of vehicle.
- Loosen left and right adjusting lock nuts or bolts. On RX7 & 929, to increase toe-in on right side, turn adjusting cam counterclockwise. To increase toe-in on left side, turn cam clockwise. To decrease toe-in on right side, turn cam clockwise. To decrease toe-in on left side, turn adjusting cam counterclockwise.
- On 323, MX-6 and 626, to increase toe-in on right side turn adjusting rod counterclockwise. To increase toe-in on left side turn rod clockwise. To decrease toe-in on right side turn rod clockwise. To decrease toe-in on left side turn adjusting rod counterclockwise.
- On Miata, to increase toe-in on right side turn adjusting cam clockwise. To increase toe-in on left side turn cam counterclockwise. To decrease toe-in on right side turn cam counterclockwise. To decrease toe-in on left side turn adjusting cam clockwise.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.