SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA1991MX-6 GT, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)DRIVELINES & AXLESAXLE SHAFTSREMOVAL, DISASSEMBLY, REASSEMBLY & INSTALLATIONINTERMEDIATE SHAFTDISASSEMBLY & REASSEMBLY
1991 Mazda MX-6 GT, Standard

Disassembly & Reassembly

1991 Mazda MX-6 GT, StandardSECTION Disassembly & Reassembly

Remove snap ring from shaft. See Figure or Figure . Press axle shaft from bearing bracket. Press shaft bearing and outer oil seal out of bearing bracket. Remove bracket front outer seal. To reassemble, reverse disassembly procedures.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.