Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA1991323 L4-1600 1597CCREPAIR AND DIAGNOSISMAINTENANCEALIGNMENTSERVICE AND REPAIRREAR WHEEL ALIGNMENTTOE-IN
1991 Mazda 323 L4-1600 1597cc
Toe-In
1991 Mazda 323 L4-1600 1597ccSECTION Toe-In
Lateral Link Locknuts:
1. Total toe-in should be 2mm ±3mm (0.08in ±0.12in), if not within spec. loosen the lateral link locknuts.
Adjust Lateral Link Adjustment Rod:
2. Turn the adjustment rod as necessary. One turn of the link changes toe 11.3mm (0.44 in).
3. After adjustments are complete, torque lateral link locknuts to 55-64 Nm (41-47 ft.lbs).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.