Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA1990B2600I LE-5, 2D PICKUP, RWD, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROLS - BASIC TESTINGRESISTOR RELAY (RX7 ONLY)
1990 Mazda B2600i LE-5, 2D Pickup, RWD, Standard
Resistor Relay (RX7 Only)
1990 Mazda B2600i LE-5, 2D Pickup, RWD, StandardSECTION Resistor Relay (RX7 Only)
- Remove air cleaner and airflow meter. Disconnect fuel pump resistor. Ensure continuity exists between terminals "a" and "b". See Fig 1 and Fig 2 .
- Measure resistance between the following terminals. Resistance between terminals "c" and "d" should be 60-92 ohms and between "e" and "f" should be .70-.94 ohms. If resistor relay does not test as specified, replace relay.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.