Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Timing Belt Replacement Reminder Reset Procedure
Replace both timing belts when warning light is illuminated or at 100, 000 miles. To reset warning light, locate Black wire, Black/Yellow and Black/White wire connectors near intermittent wiper control unit. Remove Black wire connector from either Black/White or Black/Yellow wire connector. Reconnect Black wire to opposite connector from which it was originally disconnected.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.