Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Water THERMO Sensor
Remove water thermo sensor from intake manifold. Sensor will have Blue/Red and Blue/Yellow wires attached. Place sensor in water with a thermometer and gradually heat water. Check calibration of sensor according to WATER THERMO SENSOR CALIBRATION table.
| Resistance (Ohms) | Water Temperature: °F (°C) |
|---|---|
| 1458-1782 | -4 (-20) |
| 2210-2690 | 68 (20) |
| 288-352 | 176 (80) |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.