Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Anti-Lock Brake System (ABS) Module
The ABS module is attached directly to the HCU and is the electronic control unit for all of the ABS and stability control systems. The ABS module monitors all sensor inputs and all CAN messages that relate to ABS and stability control, then directly controls the solenoid valves and the hydraulic pump motor in the HCU.
When a new ABS module is installed, it must be programmed with the vehicle configuration information and programmed with the latest level of module software. These procedures are carried out using a diagnostic scan tool, follow all scan tool instructions.
When an ABS or stability control system fault has been corrected or a new component has been installed, the ABS module must be calibrated. The calibration procedure is required for the stability control sensors to learn the zero-position of the vehicle. The calibration procedure requires the vehicle to be on a level surface and not moving. The calibration procedure (IVD Initialization) is carried out using a diagnostic scan tool.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.