SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLINCOLN2016MKZ BASE, 2.0L ENG VIN 9, AWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSCRUISE CONTROL SYSTEM (EXCEPT HYBRID)REMOVAL AND INSTALLATIONCRUISE CONTROL MODULE (CCM)REMOVAL
2016 Lincoln MKZ Base, 2.0L Eng VIN 9, AWD

Cruise Control Module (CCM): Removal

2016 Lincoln MKZ Base, 2.0L Eng VIN 9, AWDSECTION Removal
NOTE: Removal steps in this procedure may contain installation details.

  1. 1.

    WARNING: Before beginning any service procedure in this service information, refer to Safety Warnings in GENERAL INFORMATION (EXCEPT HYBRID) . Failure to follow this instruction may result in serious personal injury.

    Refer to: Health and Safety Precautions .

  1. 2.

    Remove the front bumper cover. REFER to: Front Bumper Cover .

  1. 3.

    Remove the active grille shutter. REFER to: Active Grille Shutter .

  1. 4.

    Release the CCM grommets from the ball studs and remove the CCM.
    • Disconnect the electrical connector.
GFD104189Courtesy of FORD MOTOR COMPANY

  1. 5.

    Remove the CCM bracket bolts.

    Torque

    : 20 lb.ft (27 Nm)

GFD104190Courtesy of FORD MOTOR COMPANY

  1. 6.

    Remove the CCM bracket.

    1. 1.

      Remove the CCM bracket nut.

      Torque

      : 80 lb.in (9 Nm)

    1. 2.

      Remove the CCM bracket bolt.

      Torque

      : 80 lb.in (9 Nm)

    1. 3.

      Slide the CCM bracket out of the front bumper slot.
GFD104191Courtesy of FORD MOTOR COMPANY
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.