Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLINCOLN2016MKZ BASE, 2.0L ENG VIN 9, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXDTC INDEX (POWERTRAIN - WIPER & WASHER SYSTEM)STEERING COLUMN SWITCHES DTCSSTEERING COLUMN CONTROL MODULE (SCCM)
2016 Lincoln MKZ Base, 2.0L Eng VIN 9, AWD
Steering Column Control Module (SCCM)
2016 Lincoln MKZ Base, 2.0L Eng VIN 9, AWDSECTION Steering Column Control Module (SCCM)
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B1007:09 | High-Beam Headlamp Switch: Component Failure | REFER to: Headlamps . |
| B1008:09 | Wiper Mode Switch: Component Failure | REFER to: Wipers and Washers . |
| B1051:09 | Front Washer Switch: Component Failure | REFER to: Wipers and Washers . |
| B1052:09 | Rear Washer Switch: Component Failure | REFER to: Wipers and Washers . |
| B10AD:02 | Rain Sensor: General Signal Failure | REFER to: Wipers and Washers . |
| B10AD:08 | Rain Sensor: Bus Signal/Message Failure | REFER to: Wipers and Washers . |
| B10AD:49 | Rain Sensor: Internal Electronic Failure | REFER to: Wipers and Washers . |
| B10AD:55 | Rain Sensor: Not Configured | REFER to: Wipers and Washers . |
| B1131:02 | Wiper motor module: General Signal Failure | REFER to: Wipers and Washers . |
| B1131:08 | Wiper motor module: Bus Signal/Message Failure | REFER to: Wipers and Washers . |
| B1131:11 | Wiper motor module: Circuit Short To Ground | REFER to: Wipers and Washers . |
| B1131:49 | Wiper motor module: Internal Electronic Failure | REFER to: Wipers and Washers . |
| B1131:55 | Wiper motor module: Not Configured | REFER to: Wipers and Washers . |
| B1131:9A | Wiper motor module: Component or System Operating Conditions | REFER to: Wipers and Washers . |
| B11D9:16 | Vehicle Battery: Circuit Voltage Below Threshold | GO to Pinpoint Test D |
| B11D9:17 | Vehicle Battery: Circuit Voltage Above Threshold | GO to Pinpoint Test E |
| B1298:09 | Steering Column Adjust Up Switch: Component Failure | REFER to: Steering Column . |
| B1299:09 | Steering Column Adjust Down Switch: Component Failure | REFER to: Steering Column . |
| B12A1:09 | Steering Column Adjust Out Switch: Component Failure | REFER to: Steering Column . |
| B12A2:09 | Steering Column Adjust In Switch: Component Failure | REFER to: Steering Column . |
| B12F7:09 | Single Wipe Switch: Component Failure | REFER to: Wipers and Washers . |
| B137F:09 | Steering Wheel Left Switch Pack: Component Failure | REFER to: Cruise Control . |
| B137F:11 | Steering Wheel Left Switch Pack: Circuit Short to Ground | REFER to: Cruise Control . |
| B137F:17 | Steering Wheel Left Switch Pack: Circuit Voltage Above Threshold | REFER to: Cruise Control . |
| B1380:09 | Steering Wheel Right Switch Pack: Component Failure | Refer to the Diagnosis and Test in the appropriate Information and Entertainment Systems article. |
| B1380:11 | Steering Wheel Right Switch Pack: Circuit Short to Ground | Refer to the Diagnosis and Test in the appropriate Information and Entertainment Systems article. |
| B1380:17 | Steering Wheel Right Switch Pack: Circuit Voltage Above Threshold | Refer to the Diagnosis and Test in the appropriate Information and Entertainment Systems article. |
| B13A6:09 | Lane Departure Warning (LDW) Switch Input: Component Failure | REFER to: Lane Departure Warning . |
| B1D36:09 | Turn Indicator Switch: Component Failure | REFER to: Turn Signal and Hazard Lamps . |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | CHECK vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or improper PMI procedures. If there have been recent service actions with this module, REPEAT/PERFORM the PMI procedure as directed by the diagnostic scan tool. If there have been no recent service actions, INSTALL a new module to correct the failure to retain configuration data. |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | This DTC sets if the steering wheel switches do not match the switch function configuration data in the SCCM. CHECK the parts catalog and CONFIRM that the correct SCCM and steering wheel control switches are installed in the vehicle. INSTALL the correct components, as necessary. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.