Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLINCOLN2016MKZ BASE, 2.0L ENG VIN 9, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALSTARTERSTARTING SYSTEM - 2.0L ECOBOOST (184KW/250PS) - MI4 (EXCEPT HYBRID)DIAGNOSIS AND TESTINGSTARTING SYSTEMDTC CHARTSPCM DTC CHART
2016 Lincoln MKZ Base, 2.0L Eng VIN 9, AWD
PCM DTC Chart
2016 Lincoln MKZ Base, 2.0L Eng VIN 9, AWDSECTION PCM DTC Chart
| DTC | Description | Action |
|---|---|---|
| P0512 | Starter Request Circuit - Circuit has Power With the Ignition in the OFF Position | PERFORM the Ignition Switch Component Test. Refer to Component Testing for schematic and connector information. testing. If necessary, INSTALL a new ignition switch. If the ignition switch passed the component test, REPAIR circuit CDC35 (BU/WH) for a short to power. |
| P0616 | Starter Relay "A" Circuit Low | GO to Pinpoint Test C |
| P0617 | Starter Relay "A" Circuit High | GO to Pinpoint Test C |
| P06E9 | Engine Starter Performance | If the engine cranks, Refer to Engine Controls - Introduction (Except Diesel & Hybrid) . If the engine does not crank, GO to Pinpoint Test A |
| P0706 | Transmission Range Sensor "A" Circuit Range/Performance | REFER to: Automatic Transmission . |
| P0707 | Transmission Range Sensor "A" Circuit Low | REFER to: Automatic Transmission . |
| P0708 | Transmission Range Sensor "A" Circuit High | REFER to: Automatic Transmission . |
| P1594 | Forced engine shutdown - remote start system fault, No unattended vehicle timeout | GO to Pinpoint Test F |
| P1595 | Forced engine shutdown - Remote Start System Fault, Transmission not in Park | GO to Pinpoint Test G |
| P162F | Starter Motor Disabled - Engine Crank Time Too Long | Refer to Engine Controls - Introduction (Except Diesel & Hybrid) . |
| P2533 | Ignition Switch Run/Start Position Circuit | GO to Pinpoint Test E |
| P2534 | Ignition Switch Run/Start Position Circuit Low | GO to Pinpoint Test E |
| P2535 | Ignition Switch Run/Start Position Circuit High | GO to Pinpoint Test E |
| PCM DTCs | PCM DTCs not listed in this chart | Refer to Engine Controls - Introduction (Except Diesel & Hybrid) . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.