Module Configuration and Parameter Chart

2016 Lincoln MKZ Base, 2.0L Eng VIN 9, AWDSECTION Module Configuration and Parameter Chart

The chart describes specific module configuration information:

Module Name Programmable Module Installation (PMI) Available Reprogram/Flash Capable Requires Adaptive Learning or Calibration Available Programmable Parameters
ACCM No No No None
APIM Yes Yes No None
ABS module Yes Yes ABS bleed (HEV)
Multi-calibration routine (HEV)
Inlet valve calibration (HEV)
Master cylinder isolation calibration (HEV)
IVD initialization
EPB apply and release
None
ACM Yes Yes No None
BECM Yes Yes No None
BCM Yes Yes Ambient lighting calibration
Rear view camera calibration
DRL configuration
Keyless entry/passive start enable/disable
Remote start enable/disable
Trim switch enable/disable
CCM Yes Yes No None
DSP Yes Yes No None
DACMC (Integrated with ACM except for China THX® audio system) Yes Yes No None
DC/ DC Converter Control Module (DC/DC) (HEV) No No No None
DDM Yes Yes No None
DSM Yes Yes No None
SCME Yes Yes No None
SCMG Yes Yes No None
FCIM Yes Yes No None
GWM Yes Yes No None
GSM Yes Yes No None
GFM (CD player) No No No None
GPSM Yes Yes No None
Headlamp Control Module (HCM) Yes Yes No None
HUD module No No No None
IPC Yes Yes No Automatic engine ignition shutdown (AEIS) with override
Daytime running lamps (DRL) control function
Driver Beltminder
Mid-passenger Beltminder
Passenger Beltminder
Remote start enable/disable
  • climate settings
  • driver seat
  • passenger seat
  • rear defrost
  • steering wheel
HSWM No No No None
IPMA module Yes Yes Camera calibration None
OCSM No No OCSM re-zero None
PAM (integrated with BCM) Yes Yes No None
SCMH Yes Yes No None
PSCM Yes Yes No None
PCM No Yes No None
PDM Yes Yes No None
RTM Yes Yes No None
RACM (China only) No No No None
RGTM Yes Yes Power Luggage Compartment Lid Initialization None
RCM Yes Yes No None
SODL Yes Yes No Blockage enabled
Enable/disable configuration
SODR Yes Yes No Blockage enabled
Enable/disable configuration
SCCM Yes Yes No None
SOBDMC/ TCM (HEV) Yes Yes No None
TCU Yes Yes No None
TRCM Yes Yes No None
VDM Yes Yes Suspension height sensor calibration None
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.