Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLINCOLN2016MKZ BASE, 2.0L ENG VIN 9, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSPASSIVE ANTI-THEFT SYSTEM (PATS) - VEHICLES WITH: PUSH BUTTON START (EXCEPT HYBRID)DIAGNOSIS AND TESTINGPASSIVE ANTI-THEFT SYSTEM (PATS)DTC CHARTSPCM/ SOBDMC DTC CHART
2016 Lincoln MKZ Base, 2.0L Eng VIN 9, AWD
PCM/ SOBDMC DTC Chart
2016 Lincoln MKZ Base, 2.0L Eng VIN 9, AWDSECTION PCM/ SOBDMC DTC Chart
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to: Diagnostic Methods .
| DTC | Description | Action |
|---|---|---|
| P161A | Incorrect Response from Immobilizer Control Module | The BCM ID received by the PCM/ SOBDMC does not match the ID stored in the PCM/ SOBDMC memory. PERFORM a parameter reset. Refer to: Anti-Theft Security Access . |
| P161B | Incorrect Response from Secondary Immobilizer Module | The BCM ID received by the SOBDMC does not match the ID stored in the SOBDMC memory. PERFORM a parameter reset. Refer to: Anti-Theft Security Access . |
| All other Diagnostic Trouble Codes (DTCs) | - | Refer to Engine Controls - Introduction (Except Diesel & Hybrid) . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.