Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLINCOLN2015MKS BASE, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 28 (ENGINE SYSTEM - GENERAL INFORMATION)
2015 Lincoln MKS Base, AWD
Section 28 (Engine System - General Information)
2015 Lincoln MKS Base, AWDSECTION Section 28 (Engine System - General Information)
WARNING: This page is about a different car, the 2015 Lincoln MKT. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Description And Operation
- Diagnosis And Testing
- General Procedures
- Bearing Inspection
- Camshaft Bearing Journal Diameter
- Camshaft End Play - OHC Engines
- Camshaft Journal to Bearing Clearance - OHC Engines
- Camshaft Lobe Lift
- Camshaft Runout
- Camshaft Surface Inspection
- Crankshaft Main Bearing Journal Diameter
- Connecting Rod Bearing Journal Taper and Out-of-Round
- Connecting Rod Bearing Journal-to-Bearing Clearance
- Connecting Rod Bend
- Connecting Rod Bushing Diameter
- Connecting Rod Cleaning
- Connecting Rod Large End Bore
- Connecting Rod to Crankshaft Side Clearance
- Connecting Rod Twist
- Core Plug Replacement
- Crankshaft End Play
- Crankshaft Main Bearing Journal Taper and Out-of-Round
- Crankshaft Main Bearing Journal-to-Bearing Clearance
- Cylinder Block Distortion
- Cylinder Bore Cleaning
- Cylinder Bore Out-of-Round
- Cylinder Bore Taper
- Cylinder Head Distortion
- Exhaust Manifold Cleaning and Inspection
- Flexplate Inspection
- Piston Diameter
- Piston Inspection
- Piston Pin Bore Diameter
- Piston Pin Diameter
- Piston Ring End Gap
- Piston Ring-to-Groove Clearance
- Piston Selection
- Piston To Cylinder Bore Clearance
- Powertrain/Drivetrain Mount Neutralizing
- RTV Sealing Surface Cleaning and Preparation
- Spark Plug Inspection
- Sprockets
- Valve Guide Inner Diameter
- Valve Inspection
- Valve Seat Inspection
- Valve Seat Runout
- Valve Seat Width
- Valve Spring Free Length
- Valve Spring Installed Length
- Valve Spring Squareness
- Valve Spring Strength
- Valve Stem Diameter
- Valve Stem to Valve Guide Clearance
- Valve Tappet Inspection
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.