Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLINCOLN2014MKT BASE, AWDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSANTI-THEFT SYSTEM - PERIMETERREMOVAL AND INSTALLATIONPASSIVE START ANTENNA - REARREMOVAL AND INSTALLATION
2014 Lincoln MKT Base, AWD
Removal and Installation
2014 Lincoln MKT Base, AWDSECTION Removal and Installation
- Remove the liftgate scuff plate trim panel. For additional information, refer to Interior Trim - Exploded View in INTERIOR TRIM AND ORNAMENTATION .
- Pull the red lock tab outward and disconnect the center passive start antenna electrical connector.
- Using a suitable tool (such as needle nose pliers), release the rear passive start antenna from the 2 push pins and remove the rear passive start antenna.
- To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.