Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLINCOLN2013MKT ECOBOOST, 2.0L ENG VIN 9REPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS (EXCEPT DIESEL & HYBRID) - DTC P0210 - P05C0DTC P025B: FUEL PUMP MODULE A CONTROL CIRCUIT RANGE/PERFORMANCE
2013 Lincoln MKT EcoBoost, 2.0L Eng VIN 9
DTC P025B: Fuel Pump Module A Control Circuit Range/Performance
2013 Lincoln MKT EcoBoost, 2.0L Eng VIN 9SECTION DTC P025B: Fuel Pump Module A Control Circuit Range/Performance
DTC P025B: FUEL PUMP MODULE A CONTROL CIRCUIT RANGE/PERFORMANCE
| Description: | The fuel pump control module monitors the duty cycle and frequency of the signal it receives from the PCM. The fuel pump control module determines if the signal from the PCM on the fuel pump command (FPC) circuit is a valid duty cycle and frequency. If the duty cycle or frequency is invalid, the fuel pump control module sends a 20% duty cycle signal on the fuel pump monitor (FPM) circuit to report the concern to the PCM. The test fails when the fuel pump control module is still reporting that it is receiving an invalid duty cycle or frequency from the PCM after a calibrated amount of time. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Check the harness for routing, alterations, incorrect shielding, or electrical interference from other systems. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST KC . | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.