Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Lincoln Navigator RWDFACTORY OEM SERVICE PROCEDURE
Anti-Lock Brake System And Stability Control: Specifications
MATERIAL SPECIFICATIONS
| Item | Specification | Fill Capacity |
|---|---|---|
| High Performance DOT 3 Motor Vehicle Brake Fluid PM-1-C (US); CPM-1-C (Canada) |
WSS-M6C62-A or WSS-M6C65-A1 | 1, 420 ml (3 pt) |
| Metal Brake Parts Cleaner PM-4-A or PM-4-B (US); CPM-4 (Canada) |
- | - |
| Multi-Purpose Grease XG-4 and/or XL-5 |
ESB-M1C93-B | - |
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| ABS module bolts | 2 | - | 18 |
| Air Cleaner (ACL) outlet clamp | 4 | - | 35 |
| Brake caliper anchor plate bolts | 250 | 184 | - |
| Front floor console bracket lower bolts | 40 | 30 | - |
| Front floor console bracket upper bolts | 9 | - | 80 |
| Front wheel speed sensor harness bolt | 12 | - | 106 |
| Front wheel speed sensor bolt | 18 | - | 159 |
| Hydraulic Control Unit (HCU)-to-bracket bolts | 9 | - | 80 |
| HCU bracket-to-frame bolts | 20 | - | 177 |
| Master cylinder primary and secondary brake tube fittings | 25 | 18 | - |
| Rear combination valve brake tube fitting | 20 | - | 177 |
| Rear wheel speed sensor bolt | 18 | - | 159 |
| RH and LH front brake tube fitting | 20 | - | 177 |
| Steering wheel rotation sensor bolts | 3 | - | 27 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.