Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLINCOLN2011MKZ AWD V6-3.5LREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - WIPER AND WASHER SYSTEMSWINDSHIELD WASHER CONTROL MODULESERVICE AND REPAIR
2011 Lincoln MKZ AWD V6-3.5L
Windshield Washer Control Module: Service and Repair
2011 Lincoln MKZ AWD V6-3.5LSECTION Service and Repair
Wiper/Washer Module
NOTE: Instrument panel removed for clarity.
Removal and Installation
1. Position the Smart Junction Box (SJB) aside by pushing upward then pulling outward to release it from the SJB bracket.
2. Disconnect the wiper/washer module connector.
3. Pull down on the wiper/washer module to release it from the SJB bracket.
4. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.