Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLINCOLN2010MKZ FWD V6-3.5LREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSWINDOW GLASSBACK WINDOW GLASSSERVICE AND REPAIRPROCEDURES
2010 Lincoln MKZ FWD V6-3.5L
Procedures
2010 Lincoln MKZ FWD V6-3.5LSECTION Procedures
Glass Reseal - Rear
1. Remove the C-pillar trim panel and parcel shelf, and lower the headliner.
2. Disconnect the rear window glass electrical connectors.
3. Clean the interior and exterior of the windshield glass surface with glass cleaner.
4. Cut the urethane adhesive applicator tip to specification.
5. NOTE: Use either a high ratio, electric or battery-operated caulk gun that applies the urethane adhesive with less effort and continuous bead.
NOTE: Make sure there are no gaps in the urethane adhesive bead.
Apply the urethane adhesive over the top of the existing urethane adhesive.
- Apply the urethane adhesive to the top and sides of the rear glass from the interior of the vehicle.
- Apply the urethane adhesive to the bottom of the rear glass from the exterior of the vehicle.
6. NOTE: The urethane adhesive must cure for a minimum of one hour before testing for air or water leaks.
After the urethane adhesive cures, check the rear glass seal for air or water leaks through the urethane adhesive bead and add urethane adhesive as necessary.
7. Connect the rear window glass electrical connectors.
8. Install the headliner, parcel shelf and C-pillar trim panels.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.