Power Window Switch: Service and Repair

2010 Lincoln MKZ FWD V6-3.5LSECTION Service and Repair



Window Control Switch

Fusion, Milan

NOTE: LH front shown, all others similar.











MKZ - Front Door

NOTE: LH front shown.











MKZ - Rear Door

NOTE: RH rear shown.











Removal and Installation

Fusion, Milan

1. Remove the access cover and the screw.

2. Using an appropriate non-marring trim tool, pry the rear of the switch bezel upward and then shift the switch assembly rearward to disengage the front locking tab.





MKZ

3. NOTE: For LH front window control switch assembly only, the rear retaining clip is located off-center towards the outside of the vehicle.

Using an appropriate non-marring trim tool, pry the rear of the switch bezel upward to disengage the retaining clip, then shift the switch assembly rearward to disengage the front locking tab.

All Vehicles

4. Disconnect the electrical connector(s).

5. Remove the window control switch.

6. To install, reverse the removal procedure.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.