Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLINCOLN2010MKZ FWD V6-3.5LREPAIR AND DIAGNOSISLIGHTING AND HORNSINTERIOR LIGHTING MODULESERVICE AND REPAIRINTERIOR LIGHTING CONTROL MODULE (ILCM)
2010 Lincoln MKZ FWD V6-3.5L
Interior Lighting Control Module (ILCM)
2010 Lincoln MKZ FWD V6-3.5LSECTION Interior Lighting Control Module (ILCM)
Interior Lighting Control Module (ILCM)
Removal and Installation
1. Remove the passenger air bag module. For additional information, refer to Restraint Systems.
2. Remove the 2 bolts and the Interior Lighting Control Module (ILCM).
- To install, tighten to 1.6 Nm (14 lb-in).
3. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.