Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLINCOLN2009TOWN CAR SIGNATURE LIMITED, 4.6 VREPAIR AND DIAGNOSISRESTRAINTSRESTRAINTS CONTROL SYSTEMSSAFETY BELT SYSTEMREMOVAL AND INSTALLATIONSAFETY BELT RETRACTOR AND PRETENSIONERINSTALLATION
2009 Lincoln Town Car Signature Limited, 4.6 V
Safety Belt Retractor and Pretensioner: Installation
2009 Lincoln Town Car Signature Limited, 4.6 VSECTION Installation
- Position the front safety belt retractor and pretensioner.
- Install the bolt.
- Tighten to 40 Nm (30 lb-ft).
- Connect the electrical connector.
NOTE:
Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
WARNING:
Always tighten the fasteners of the restraints control module (RCM) and impact sensor (if equipped) to the specified torque. Failure to do so may result in incorrect restraint system operation, which increases the risk of personal injury or death in a crash.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.