Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSLINCOLN2009NAVIGATOR L RWDREPAIR AND DIAGNOSISELECTRICALGAUGESINSTRUMENT PANEL & CONSOLEREMOVAL AND INSTALLATIONPOWER POINTREMOVAL

2009 Lincoln Navigator L RWD

Power Point: Removal

2009 Lincoln Navigator L RWDSECTION Removal

NOTE: Power point cover may differ depending on location.

Open the power point cover.
Install the Power Point Socket Remover in one of the power point socket slots.

Fig 1: Identifying Power Point Socket Tool And Slot
Courtesy of FORD MOTOR CO.
Position the Power Point Socket Remover so that it engages in the adjacent slot.

Fig 2: Positioning Power Point Socket Remover
Courtesy of FORD MOTOR CO.
Using the Power Point Socket Remover, pull the power point socket out of the retainer.

Fig 3: Pulling Power Point Socket Out Of Retainer
Courtesy of FORD MOTOR CO.
Disconnect the electrical connector.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.