Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLINCOLN2009NAVIGATOR L RWDREPAIR AND DIAGNOSISBODY & FRAMESEATSSEAT SYSTEM - SEATINGREMOVAL AND INSTALLATIONSEAT CONTROL SWITCH - THIRD ROWREMOVAL AND INSTALLATION
2009 Lincoln Navigator L RWD
Removal and Installation
2009 Lincoln Navigator L RWDSECTION Removal and Installation
- Release and remove the tray from the RH rear quarter trim panel.
-
NOTE: The LH and RH switch wiring harness electrical connectors are not interchangeable.
Remove the affected seat control switch.
- Release the 2 retaining tabs and detach the seat control switch from the RH rear quarter trim panel.
- Pull the seat control switch through the opening and disconnect the electrical connector.
- To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.