Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Programming Memory Positions
- Place the vehicle ignition to ON.
-
NOTE: To program an Integrated Keyhead Transmitter (IKT) (remote entry transmitter), refer to Remote Keyless Entry Transmitter Programming and Remote Memory Activation in HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS .
To set memory position(s) move the memory driver seat, memory exterior mirrors (if equipped), memory adjustable pedals (if equipped) and memory tilt steering column (if equipped) to the preferred position using the appropriate switch(es).
-
NOTE: Activation of the driver seat control switch, adjustable pedal control switch, exterior mirror control switch or power tilt steering column switch during memory programming will abort the operation.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.