Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Electronic Automatic Temperature Control (EATC) Module and Electronic Manual Temperature Control (EMTC) Module Cold Boot Process
The purpose of the cold boot process is to allow the DATC/EATC or EMTC module to reinitialize and calibrate the actuators. To carry out the cold boot process, follow the steps below.
- Turn the ignition switch to the OFF position.
- Disconnect the DATC/EATC or EMTC module electrical connectors.
- Wait one minute.
- Connect the DATC/EATC or EMTC module electrical connectors.
- Turn the ignition switch to the ON position.
- Select any position except OFF on the DATC/EATC or EMTC module.
The DATC/EATC or EMTC module will now initialize and calibrate the actuators. Calibration of the actuators will take approximately 30 minutes.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.